Measures, cuts, installs and repairs soft and resilient floor coverings. Registration or licensing may be required.

Skill Level

3

Specialisations

• Carpet Layer
• Parquetry Layer

Unless you are exempt in very limited circumstances, you are required to have a positive Skills Assessment to apply for the visas listed above.

Skills Assessment authority for Floor Finisher  is Trades Recognition Australia (TRA). To have a positive skills assessment, you must meet the following criteria:

• Three Programs for skills assessment with TRA.
  • Program A -  Offshore Skills Assessment (OSAP)
    • If your passport is on this OSAP Nominated Occupation and Country list next to your occupation, you must apply through OSAP. If your passport is not on this list, apply through Program B or C.
    • OSAP Pathway 1– for applicants who do not hold an Australian qualification in their trade but hold a qualification which is equivalent to an AQF cert
    • OSAP Pathway 2 –  for applicants who hold:
      • a relevant Australian qualification, or
      • a current identified Australian occupational licence
    • To be eligible to apply for the skills assessment program, you must be able to show you have completed full-time paid employment in your nominated occupation, or an occupation that is directly related to your nominated occupation  To view the employment standards click here.
  • Program B Migration Skills Assessment
    • You must have a qualification directly related to your nominated occupation  or at least 3 years of relevant experience
    • If you have obtained a qualification internationally or an Australian qualification that was not through the Australian Recognition of Learning process, you are required to demonstrate 3 years full time or equivalent post-qualification experience
    • If you have obtained an Australian qualification issued through the Australian Recognition of Learning process, you are required to demonstrate 3 years full-time or equivalent post-qualification experience OR 6 years full-time or equivalent experience which can be either pre- or post-qualification
  • Pathway B - Temporary Skills Shortage Skills Assessment
    • For applicants who require a skills assessment to apply for the Temporary Skill Shortage visa (subclass 482)

Did you know?

As part of the OSAP program you will be required to participate in a technical assessment of your skills and knowledge. This will be conducted by a qualified assessor who will also be a qualified tradesperson in your nominated occupation.

measure, cut, install and repair soft and resilient floor coverings.

Tasks

• measuring areas to be covered and consulting plans to estimate quantities of floor covering materials required
• preparing surfaces for covering and removing baseboard trims
• measuring, cutting and fixing underlay materials
• laying coverings, such as carpets, linoleum, parquetry blocks, cork tiles and other resilient flooring materials, over floors, matching patterns, cutting shapes around fixtures and trimming edges
• securing floor coverings and fitting edge trims in doorways
• sanding, staining and applying finishing coatings to timber floors
• may install wall, ceiling, counter and bench coverings

Skill Level

Most occupations in this unit group have a level of skill commensurate with the qualifications and experience outlined below.
In Australia:
AQF Certificate III including at least two years of on-the-job training, or AQF Certificate IV (ANZSCO Skill Level 3)

In New Zealand:
NZ Register Level 4 qualification (ANZSCO Skill Level 3)

At least three years of relevant experience may substitute for the formal qualifications listed above. In some instances relevant experience and/or on-the-job training may be required in addition to the formal qualification.
Registration or licensing may be required.

Occupations in this Group

• 332111 Floor Finisher